How to
measure a cartridge
- Measure the outside diameter of the filter cartridge in inches.
- Measure the length of the filter cartridge from end cap to end cap.
Do not include things like handles or threaded bottoms in the measurement.
- Identify the end cap configuration. Is it threaded with a handle,
or open on both sides? Look at the pictures below to help you better
identify the end cap. If it is open measure the inner diameter of the
whole.
- To better identify the cartridge, count the number of pleats. This
allows us to know the square footage of the cartridge in question.
 How
to clean your cartridge
When the pressure gauge on your filter tank reaches 8 p.s.i. above the
pressure recorded when a new cartridge is installed, or when there is
a noticeable decrease in the pressure coming from your return jets, it
is time to clean your cartridge.
Remove the cartridge from the filter canister and dislodge and loose
debris by directing a stream of water from a garden hose between each
pleat. Do not use a high-pressure car wash wand or a stiff brush to clean
your cartridge. These abrasive methods may damage the filter media.
Soak the cartridge in a commercially prepared cartridge cleaner to remove
oils or other organics. If stubborn stains persist, soak the cartridge
overnight in a solution of one-quart household bleach to five gallons
of water.
Rinse the cartridge thoroughly with clean fresh water and return it to
the filter tank. Secure the tank lid and restart your filtration system
per manufacturer's instructions.
Always follow your filter equipment manufacturer's instructions when
removing or reinstalling your filter cartridge. Always exercise extreme
care when handling bleach or any other chemical. We recommend against
acid washing your filter cartridges. |
)
)
)
)
)
)
)
)
)
)
)
)
)
